Editorial Note: This article is written with editorial review and topic relevance in mind.
Finding your gateway information (default password, network name, and serial number) In the username field, enter admin (if it's not there already). Am i correct in saying that the vlans and other subnets go on interface g0/0/1 with an ip address of, say, 172.16.0.1 255.255.255.224 for subnet 0 and 172.16.1.1.
A Tale of Two Cities (1980) movie vs book
In the password field, enter the device access code from the bottom of your arris nvg448 gateway (take a picture of the. Aaa was correct for netconf and the force configuration push from dnac did not fix the issue (i didn't try opening a tac. Connect your pc to the device using.
If you close the browser tab or window and then go back to the gateway page within a short period of time, you'll still be logged in.
Scenario 1 user was using wlc 5500 controller and once the end clients get the dhcp address but the page is not. Introduction cisco wireless 1.1.1.1/login.html redirect issues. If your device supports bluetooth, it loads with the initial setup tasks preconfigured. Hi, i have a couple of switches configured and when i try to ssh into one switch from another i get the error:
I had this same issue on 3 switches today. Router a believes that router b will only understand subnets with a /30 netmask, so it does not tell router. There is no log out button for the actiontec gateway. The link from router a to router b has the address 172.16.0.1/30.
If the device new you need to quick setup guide :
